MX ECM HARNESS

This is the cable to use with the MX ECM to bench

flash and test ECM’s.

You can use this to test an ECM by taking the truck wiring

out of the picture. 

     And also run the engine with no truck hooked

or test stand operation.

This harness has a toggle switch to simulate the ignition switch.

It is fuse protected

As all my harnesses I carry a stock for immediate shipping.

I ship on a daily basis.

                                          

  I also have listings for bench harnesses for Caterpillar ECM's.

And Paccar MX engines.

Detroit engines.

I have been a diesel tech for over 30 years.

I make up all sorts of diagnostic tools for electronics.

Any questions please ask.

                                                                                                                                                                                

Thanks

 

Your form message has been successfully sent.

You have entered the following data:

Please fill out the form below and hit the send button. I will send you an invoice. Shipping in the US is FREE!

Please correct your input in the following fields:
Error while sending the form. Please try again later.

Note: Fields marked with * are required

Print Print | Sitemap
© MIKE'S POWER WIRE